2015 latest Digiprog 3 Odometer correction tool has newly upgraded to V 4.94. Digiprog 3 V4.94 newest version added more vehicle models. Do you know the new feature of v4.94 digiprog 3? Below Vipprogrammer.com sharing Digiprog 3 4.94 setup guide for China Digiprog iii V4.94 programmer.
User guide for China Digiprog 3 4.94 programmer:
1. Connect the obd2tuning.com digiprog 3 4.94 main unit into the OBD diagnostic socket, but do not use the cigar lighter lead. Otherwise, it will lose the warranty.
2. After well connect with vehicle, the China digirog 3 main unit will power on, the device is loading the system.
3 Then the device screen will display digiprog III software version information. Software is marked as s unique 12 digit electronic serial number.
4. When your digiprog 3 4.94 from obd2tuning.com has finished loading an information screen will appear with a disclaimer regarding the use of the machine.
5. Click “Check / Tick” button to start using the digiprog 3 odometer correction tool.
6. The digiprog china obd2tuning will require password to enter the system. The default password is “1″.
7. Welcome the main interface. You are also allowed to check the software marked red on the picture below.
8. Select the function you need to do and follow the screen instruction.
The V4.94 digiprog 3 comes with ST01 or ST04 cable, so you do not have to buy extra cable.
NOTE:
A regulated 12 volt power supply should be used to power your digiprog III. If power up by above 13.5 volts is used to power the machine, damage may be caused to the main circuit board and it will need to be sent to your digiprog III V4.94 dealer for repair.
User guide for China Digiprog 3 4.94 programmer:
1. Connect the obd2tuning.com digiprog 3 4.94 main unit into the OBD diagnostic socket, but do not use the cigar lighter lead. Otherwise, it will lose the warranty.
2. After well connect with vehicle, the China digirog 3 main unit will power on, the device is loading the system.
3 Then the device screen will display digiprog III software version information. Software is marked as s unique 12 digit electronic serial number.
4. When your digiprog 3 4.94 from obd2tuning.com has finished loading an information screen will appear with a disclaimer regarding the use of the machine.
5. Click “Check / Tick” button to start using the digiprog 3 odometer correction tool.
6. The digiprog china obd2tuning will require password to enter the system. The default password is “1″.
7. Welcome the main interface. You are also allowed to check the software marked red on the picture below.
8. Select the function you need to do and follow the screen instruction.
The V4.94 digiprog 3 comes with ST01 or ST04 cable, so you do not have to buy extra cable.
NOTE:
A regulated 12 volt power supply should be used to power your digiprog III. If power up by above 13.5 volts is used to power the machine, damage may be caused to the main circuit board and it will need to be sent to your digiprog III V4.94 dealer for repair.
Comments
Post a Comment